rev. 07/02/09 SNC70-HXP form-in-place typical values SNC70-HXP form-in-place a rapid cure, nickel-coated graphite-filled silicone elastomer form-in-place gasket material. laird technologies introduces another product in the emi sentry family. these form-in-place pastes are extremely fast curing with reliable shielding effectiveness and strength laird technologies form-in-place is an automated system for dispensing conductive elastomer emi shielding and grounding gaskets onto metal or plastic substrates. this product is particularly ideal for base stations, pdas, pc cards, radios, mobile phones, as well as many other cast enclosures and packaged electronic assemblies. (a) compression-defection bead size 0.60 mm (h) x 0.70 mm (w) (b) time to effectively cure a bead will necessarily depend on individual conditions, including but not limited to bead size, shield size and weight, oven capacity, and oven ramp-rates. americas: +1 866.928.8181 europe: +49 8031.2460.0 asia: +86 755.2714.1166 www.lairdtech.com test method units SNC70-HXP elastomer silicone filler nickel/graphite electrical properties volume resistivity ohm-cm 0.030 shielding effectiveness mil-dtl-83528c 200 mhz to 10 ghz para. 4.5.12 db >90 physical properties hardness astm d2240 shore a 70 density (cured) astm d792 g/cm 3 2.5 density (uncured) lt-fip-cle-09 g/cm 3 2.3 compression set astm d395 % 15 adhesion strength (al) lt-fip-cle-03 n/cm 2 >180 compression-defection (a) lt-fip-cle-07 at 20% compression lb/in 3.2 at 40% compression lb/in 11.5 temperature range c -50c to 150c ul rating ul-94 v0 curing requirements cure conditions 120c minimum cure time at 125c (b) lt-fip-cle-14 1 hour * does not represent actual color emi-ds-fip-SNC70-HXP 0113 any information furnished by laird technologies, inc. and its agents is believed to be accurate and reliable. responsibility for the use and application of laird technologies materials rests with the end user, since laird technologies and its agents cannot be aware of all potential uses. laird technologies makes no warranties as to the fitness, merchantability or suitability of any laird technologies materials or products for any specific or general uses. laird technologies shall not be liable for incidental or consequential damages of any kind. all laird technologies products are sold pursuant to the laird technologies terms and conditions of sale in effect from time to time, a copy of which will be furnished upon request. ? copyright 2012 laird technologies, inc. all rights reserved. laird, laird technologies, the laird technologies logo, and other marks are trade marks or registered trade marks of laird technologies, inc. or an affiliate company thereof. other product or service names may be the property of third parties. nothing herein provides a license under any laird technologies or any third party intellectual property rights.
|
